When using high-speed dispersers, in order to ensure safe and efficient operation and extend the life of the equipment, the following points need to be noted:
First, equipment inspection and preparation for use
Component inspection:
Before use, be sure to check whether the various parts of the disperser are in good condition, especially whether the rotating blade is sharp and without damage, whether the bearing is flexible, and whether the motor is working normally.
Check whether the hydraulic oil level is normal, and when the hydraulic oil level is low, it should be added to the specified oil level.
Check whether the fasteners are loose and whether the sealing parts are leaky.
Check whether the power connection is stable to prevent potential hazards such as electrical spark or short circuit.
Material preparation:
According to the nature of the material to be treated, select the appropriate dispersion type and parameter Settings.
When adding materials, ensure that the materials meet the requirements of the equipment, and avoid adding too large or strong materials to cause equipment damage.
Second, the operation process
Safe operation:
Operators should wear protective clothing to avoid injuries caused by splashing materials during the dispersion process.
Before activating the disperser, ensure that all personnel are away from the equipment to prevent accidental injury.
Strictly abide by the operating procedures. Do not arbitrarily adjust the device parameters or open the device shell during operation.
If there is an abnormal situation, such as abnormal noise, abnormal vibration or overheating, it should be stopped immediately for inspection, and then continue to use after troubleshooting.
Correct operation:
Before starting the device, ensure that the dispersion container is properly installed and securely secured.
When adjusting the speed of the disperser, the speed should be gradually increased or decreased to avoid sudden changes in the impact of the equipment.
In the dispersion process, the dispersion of the material should be checked regularly to avoid excessive dispersion or insufficient dispersion.
Do not idle the equipment, especially when the speed of the disperser exceeds the specified value, so as not to damage the equipment.
Third, maintenance and maintenance
Regular inspection and maintenance:
Check the wearing parts of the equipment regularly, such as bearings, oil seals, etc., and replace them immediately if found to be worn.
Regularly check the hydraulic oil cooling system of the equipment to maintain the normal operating temperature range of the hydraulic oil.
Clean the inside of the equipment regularly to avoid material residue affecting the dispersion effect and equipment life.
Periodically check the electrical connection and grounding of the equipment to ensure the safe operation of the equipment.
Lubrication and cleaning:
Regular lubrication of motors and bearings to ensure smooth operation of equipment.
Clean the dust and stains on the surface of the equipment regularly to keep the equipment clean and tidy.
When the equipment is not used for a long time, the power supply should be cut off and comprehensive cleaning and maintenance should be carried out.
Fourth, other precautions
Avoid overload:
Do not allow the equipment to be overloaded for a long time to avoid damage to the equipment.
Environmental requirements:
The device should be placed in a well-ventilated, dry environment without corrosive gases.
Professional operation:
It is recommended that professionally trained personnel operate the device to ensure the normal operation and prolong the service life of the device.
By following the above usage considerations, you can ensure the safe and efficient operation of the high speed disperser and extend the service life of the equipment.
